Multi-Tech ISIHI-2S Specifikace stáhnout pdf (Strana 18)

18 MultiModemISI Hybrid Series, ISIHI-2S/2U

Chapter 2—Hardware Installation

Installing the ISIHI-2S/2U

Installing the ISIHI-2S/2U includes setting the I/O address DIP switches and the IRQ

jumper. You can skip this section if you select the default values. Default values are I/O

address: 210 hex and IRQ: 10.

1. Before handling the ISIHI-2S/2U, discharge any static in your body by touching a

piece of grounded metal such as the computer chassis.

2. Carefully remove the ISIHI-2S/2U from its antistatic bag, handling it only by the

mounting bracket and edges. Do not touch the gold-plated connectors along the

bottom edge. (You may want to save packaging for future use.)

3. Visually inspect the ISIHI-2S/2U. If you have any concerns about its condition, call

Technical Support at (612) 717-5863.

Line 1 Jack

Line 2 Jack

I/O Address

DIP Switch

IRQ Jumper Block

4. Make sure your computer and any peripheral equipment connected to it are turned off.

Failure to do so can damage both the ISIHI-2S/2U card and your PC. You can install

the ISIHI-2S/2U in a PC-AT, 386, 486, or Pentium equivalent ISA bus computer.

5. Remove the cover of your computer as instructed in your computers documentation.

6. Locate the unused slot you will be using for your ISIHI-2S/2U card and remove the

slot cover according to instructions in your computers documentation.

7. Check the settings of the I/O address switch and the IRQ jumper to ensure they are set

properly for your installation.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 187 188

Žádné komentáře

Multi-Tech ISIHI-2S Specifikace Strana 18